Hengstler eXtendo X-80 - ESC [F0]+[08]+[01]+[N] Bar Code Text Subtitle Setting

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 54 of 95
2.1.41 ESC [F0]+[08]+[01]+[n] Bar code text subtitle setting
[Name] Bar code text subtitle setting
[Function] This command allows enabling or disabling of the bar code text subtitle
[Code] [1B]
16
+ [F0]
16
+ [08]
16
+ [01]
16
+ [n]
[27]
10
+ [240]
10
+ [08]
10
+ [01]
10
+ [n]
[Description]
1. The “ESC [F0]+[08]+[01]+[n]” command enables/disables bar code text subtitling and specifies it’s
appearance.
2. Parameter [n] specifies bar code text subtitling enabled/disabled, font size 8x16/12x24 and font
source primary/secondary character set.
Subtitle Fonts
Size
Primary Font
Secondary Font
8x16
[01]
16
[09]
16
12x24
[03]
16
[0B]
16
16x32
[05]
16
[0D]
16
20x40
[07]
16
[0F]
16
3. Parameter [n] has following bit map:
Bit Status Caption
0 Bar Code Plain Text Subtitle 0: Disabled 1: Enabled
1-2 Font size 00: 08x16, 01: 12x24, 10: 16x32, 11: 20x40
3 Font source 0: Primary 1: Secondary
4-7 Reserved 0 (these values should always be set to "0")
4. Bar code text subtitling is disabled by default.
5. The bar code text subtitling may be unreadable or incorrect if the bar code dimension exceeds
the paper width.
6. Since the internal primary or secondary font is used for bar code text subtitling, a replacement of
the default fonts might result in an incorrect subtitling.