eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 60 of 95
Printer Part
Number
17
The first 16 bytes of this string contain the printer part number in
ASCII format. The last byte is a NUL character, which acts as a
string terminator. Note that these are all 8-bit, unsigned
characters.
Printer Serial
Number
17 The first 16 bytes of this string contain the printer serial number
in ASCII format. The last byte is a NUL character, which acts as
a string terminator. Note that these are all 8-bit, unsigned
characters.
Date of
Manufacture
17
The first 16 bytes of this string contain the printer’s date of
manufacture in ASCII format. The last byte is a NUL character,
which acts as a string terminator. Note that these are all 8-bit,
unsigned characters.
System
Configuration
4
Each of the 8 nybbles of the System Configuration is available
as an indicator for the following purposes. Note that this is a 32-
bit unsigned integer.
No.
2 - 0
(0=LSN)
Model Type
000 = X-56
3E8 = X-80
FFF = Custom
3 Reserved:
F = default
4 Cutter type:
0 = none or manual
1 = Twincut, full and partial cut
2 = Twincut, full cut only
3 = Rotary
4 = Pizza
5 Communications interface:
0 = unknown
1 = RS-232
2 = USB
6 Operating voltage:
0 = unknown
1 = 8 VDC
2 = 12 VDC
3 = 24 VDC
7 Printhead type;
0 = unknown
1 = 56 mm 448 dots
2 = 80 mm 640 dots
System Sensors 4
Each of the 8 nybbles of the System Sensors is available as an
indicator for the following purposes. Note that this is a 32-bit
unsigned integer.
No.
Definition
3 - 0
(0=LSN)
Reserved;
FFFF = Default
4 Paper exit (output) sensor (TOF);
0 = none
1 = Reflex sensor
2 = Through-beam/through-light sensor
5 Printhead up sensor:
0 = none
1 = Switch
6 Paper entry sensor (#2):
To Next Page
Loading...
