Hengstler eXtendo X-80 - Temperature;Humidity Ratings; Warranty Period

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 61 of 95
0 = none
1 = Reflex sensor
2 = Through-beam/through-light sensor
7 Paper entry sensor (#1);
0 = none
1 = Reflex sensor
2 = Through-beam/through-light sensor
System
Features
4 Each of the 8 nybbles of the System Features is available as an
indicator for the following purposes. Note that this is a 32-bit
unsigned integer.
Nybble
No.
Definition
2 - 0
(0=LSN)
Reserved;
FFF = Default
3 Firmware features:
0 = Advanced configuration
1 = Basic configuration
4 Temperature/humidity ratings:
0 = Maximum temp/humidity range
1 = Limited temp/humidity range
5 Maximum print speed:
0 = 250 mm/sec
1 = 130 mm/sec
7-6 Warranty period:
00 = undefined
01 = 0.5 years
02 = 1 year
03 = 1.5 years
04 = 2.0 years
05 = 2.5 years
06 = 3.0 years
Firmware Part
Number
17 The first 16 bytes of this string contain the firmware part number
in ASCII format. The last byte is a NUL character, which acts as
a string terminator. Note that these are all 8-bit, unsigned
characters.
Firmware
Version Number
11
The first 10 bytes of this string contain the firmware version
number in ASCII format in the form “Rx-Vy.zzb”. The last byte is
a NUL character, which acts as a string terminator. Note that
these are all 8-bit, unsigned characters.
Firmware Date 13
The first 12 bytes of this string contain the firmware date in
ASCII format in the form “mmm dd yyyy”. The last byte is a NUL
character, which acts as a string terminator. Note that these are
all 8-bit, unsigned characters.
Firmware Patch
Code
4
Bit No.
Definition
0 Firmware patch for controller 2684078 ver. A
1 = patch installed, 0 = patch not installed
1 Firmware patch for inverse printhead switch:
1 = patch installed, 0 = patch not installed
2-31 Reserved; will read out as “0”.
PRINTER SENSOR PACKET
Description
# Bytes
Definition
Header 4
[1B]+[FF]+[04]+[m], where [m] is the number of bytes of status
data following the [m]. Note that the first two header bytes are
the same for all Status Packets, while byte 3 defines the type of
packet. Here, the [04] indicates a Printer Sensor Packet.