Hengstler eXtendo X-80 - ESC [F0]+[02]+[N]+[D1]

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 65 of 95
2.1.46 ESC [F0]+[02]+[n]+[d1]..[dn] Print uncompressed
graphics
[Name] Print uncompressed graphics
[Function] This command generates a printout of a single dot line as uncompressed graphics.
[Code] [1B]
16
+ [F0]
16
+ [02]
16
+ [n]
16
+ [d1]..[dn]
[27]
10
+ [240]
10
+ [02]
10
+ [n]
10
+ [d1]..[dn]
[Description]
1. The “ESC [F0]+[02]+[n]+[d1]..[dn]” command defines and causes the printing of a single graphic
dot line the full width of the printhead.
2. Parameter “n” specifies the number of bytes needed to fully define the graphic dot line. In the
data that follows ([d1]…[dn]), dn is therefore the last data byte of the encoded data. The values
for “n” are as follows.
Printer Type n
10
n
16
X-56, 203 dpi 56 38
X-80, 203 dpi 80 50
3. Each bit of the data bytes [d1] to [dn] represents a dot on the thermal printhead. A dot is on if its
corresponding bit is a “1” and off if it is a “0”.
4. The leftmost dot in a dot line is represented by the MSB of byte d1 (first data byte).
5. The rightmost dot in a dot line is represented by the LSB of byte dn (last data byte).
6. Any other print format settings (E.G., inverse, double width, etc.) have no effect on this command.