Hengstler eXtendo X-80 - ESC [F1]+[01]+[11]+[05]+[M1]

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 76 of 95
2.1.56 ESC [F1]+[01]+[11]+[05]+[m1]..[m16] Customer Serial
Number Specification
[Name] Customer serial number specification
[Function] This command is used to specify a 16 character maximum customer serial number.
[Code] [1B]
16
+ [F1]
16
+ [01]
16
+ [11]
16
+ [05]
16
+ [m1] ... [m16]
[27]
10
+ [241]
10
+ [01]
10
+ [17]
10
+ [05]
10
+ [m1] ... [m16]
[Description]
1. The “ESC [F1]+[01]+[11]+[05]+[m1]..[m16]” command specifies an alphanumeric customer-
specified serial number.
2. The customer-specified serial number may be up to 16 alphanumeric characters long. The values
of [m1] to [m16] should be printable ASCII characters, with the exception of the null character
[0]
16
. The serial number must have a following ASCII null character (e.g. [0]
16
) if its length is less
then 16 characters. If the first character [m1] is a null character, then the customer-specified
serial number is treated as undefined.
3. If defined, then the eXtendo
®
prints the customer-specified serial number when paper is inserted
into the eXtendo
®
, and transmits it in the Status Packets (see command “GS a + [n]”, Request
Printer Status).
4. The customer-specified serial number is stored in flash memory and is printed with the header
data every time the header data is printed.