Hengstler eXtendo X-80 - ESC [F2]+[0 B]+[01]+[N] Reload Paper

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 81 of 95
2.1.61 ESC [F2]+[0B]+[01]+[n] Reload Paper
[Name] Reload Paper command
[Function] This command causes paper which has been unloaded in an X-56 Feed printer to
be reloaded so that the printer is ready to print.
[Code] [1B]
16
+ [F2]
16
+ [0B]
16
+ [01]
16
+ [n]
[27]
10
+ [242]
10
+ [11]
10
+ [01]
10
+ [n]
[Description]
1. NOTE: This command is used only by the X-56 Feed family of printers and is ignored on all
other versions.
2. The “ESC [F2]+[0B]+[01]+[n]” command is used to cause paper which has been unloaded in an
X-56 Feed printer to be reloaded so that the printer is ready to print.
3. The value “[n]” sets the Reload speed in mm/sec, and has a range of [0]
16
to [FF]
16
. While this
value may vary, an initial value of [46]
16
is recommended.
4. The “Unload Paper” command “ESC [F2]+[0A]+[02]+[n]+[m]” is used to unload the paper from
under the thermal printhead.