Need help?Do you have a question about the Heska Vet/IV 2.2 and is the answer not in the manual?
Flow Rate| micro flow rate | 0.1 to 99.9 ml/hr |
|---|---|
| macro flow rate | 1 to 999 ml/hr |
| KVO rate | 0.1 to 5 ml/hr |
Total Infusible Volume| micro total infusible volume | 0.1 to 2, 500 ml |
|---|---|
| macro total infusible volume | 1 to 9, 999 ml |
Power| power supply | 100–240 VAC, 50/60 Hz |
|---|---|
| battery type | Nickel-Cadmium 7.2V, 1, 100 mAh |
| battery operation | 6–7 hours at 120 ml/hr |
Operating Environment| accuracy | ± 5% |
|---|---|
| maximum pressure | 12 psi |
| air sensor | Ultrasonic |
Weight and Dimensions| dimensions | 5.4” x 5.4” x 2.8” (W × H × D) |
|---|---|
| dimensions metric | 138 mm x 138 mm x 72 mm (W × H × D) |
| weight | 2.6 lbs (1, 100 g) |
Defines the intended use of the Vet/IV 2.2 Infusion Pump for veterinary use only.
Lists the key features of the Vet/IV 2.2 Infusion Pump, including its capabilities and design.
Explains the meaning of warning, caution, and note symbols used throughout the manual.
Specifies the compatible IV sets and calibration requirements for the infusion pump.
Describes the procedure to test the basic operation and functionality of the infusion pump.
Details the steps to test the air-in-line alarm function of the infusion pump.
Explains how to test the door open alarm functionality of the infusion pump.
Details the procedure to test the high pressure (occlusion) alarm of the infusion pump.
Covers the fundamental steps for operating the infusion pump for fluid delivery.
Explains how to activate the lockout function to prevent unauthorized setting changes.
Provides instructions on how to deactivate the lockout function and regain access to settings.
Lists potential problems, their causes, and solutions for pump alarms and messages.
Outlines the policy and procedures for obtaining service and repair for the infusion pump.
Provides contact information for Heska's Technical Support Services for assistance.
To Next Page