MC3761 Online Manual Eng Spa 022521
Inspection
After unpacking your cooler, carefully inspect for any dam-
age that may have occurred during transit. Inspect for
loose, missing or damaged parts. Note: wheels & hardware
are located in a compartment on the bottom side of the
cooler. Refer to pics at the bottom of this page.
Contents: Evaporative Cooler (1), Hardware Bag/Hose
Adapter (1), Caster Wheels (4).
Visit Hessaire.com to request replacement parts if any of
these items are missing.
1 Install Casters: Locking in front
2 Install Hose Adapter
(Not For Indoor Use)
3 Plug In To Power
Supply
4 Fill Cooler
5 Turn On & Enjoy
Quick Start
A
C D
Lay Cooler Down
Remove Contents
Install Casters
B
2
Remove Screws
Open Disposable
Access Panel
Note: Media pads may have a slight odor upon initial start
up but will go away with continued use.
Cable Lock
Opening
Features
Control Panel For M, V & M150/M250
Switch for Fan Speeds: 4 Positions (OFF, LOW, MED, HIGH)
Switch for Pump: ON/OFF
Switch for Swing (oscillation): ON/OFF
Control Panel For MC37A Model
Swing Button: Press to turn ON/OFF
Timer Button: Lit when engaged. Press to select desired
time. All features will stop when time expires.
Pump Button: Press for ON/OFF. Pump is ON when light is
lit.
Power Button: Green light—all functions operable. Red
light—all functions disabled.
Remote Control Functions:
Pump
Timer
Power
Swing
(used in MC37A model only)
3
Fan Speed
To Next Page
Loading...
