FCC Caution:
This device complies with Part 15 of FCC Rules. Operation is subject to the
following two conditions:(l) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may causeundesired operation.
Warning! Any changes or modifications not expressly approved by the party
responsible for compliance could void the use's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frenquency energy
and, if not installed and used in accordance with the instructions, may causeharmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult Customer Service or an experienced radio/ TV technician for help.
Manufacturer
Guangzhou Mashanghe Information Technology Co., Ltd.
Address: Room C308, No. 7 Songgang Street, Cencun, Tianhe District,
Guangzhou, China
13
To Next Page
Loading...