We recommend that you clean the styler around every
20 uses, or every time the Keratin Boost needs to be
refilled. Clean it by adding clean water in the tank and
letting the water flow through the system, by pressing
the vacuum button.
After cleaning, empty out any remaining water and refill
the styler with Keratin Boost.
We also recommend cleaning the plates of the styler
with either ethanol or alcohol. This both cleans the
surface and removes eventual residues of the Keratin
Boost to avoid clogging up the holes in the plates.
Please note: The styler is not waterproof. A small mall
amount of alcohol will not damage the styler but avoid
getting fluids into the housing of the tool.
NOURISHING STYLER
UK > CLEANING & MAINTENANCE GUIDE
To Next Page
Need help?
General
