What to do if coffee brewing cycle does not function on Hi-Fly Espresso HFE98-28?
If the coffee brewing cycle on your Hi-Fly Espresso Coffee Maker isn't working, it might be because the handle microswitch isn't activated. Make sure to lower the handle to the appropriate position. Also, check if the coffee pod compressor is obstructed, and remove any obstructions from the coffee pod holder.
Why ON/OFF LED does not illuminate on Hi-Fly Espresso Coffee Maker?
If the ON/OFF LED on your Hi-Fly Espresso Coffee Maker isn't lighting up, it could be due to a couple of reasons. First, the unit might not be getting power, in which case you should repair and adjust as needed. Second, the electrical connector might not be properly fitted into the socket, so ensure it fits correctly.
What to do if NO WATER LED is illuminated on Hi-Fly Espresso HFE98-28?
If the NO WATER LED is illuminated on your Hi-Fly Espresso Coffee Maker, it means water isn't reaching the unit. Try connecting or adjusting the water supply. Also, check the water connector to ensure it is properly fitted in the socket and adjust it if necessary.
Why is water leaking from the coffee pod holder of Hi-Fly Espresso HFE98-28 Coffee Maker?
If water is leaking from the coffee pod holder of your Hi-Fly Espresso Coffee Maker, it may be due to the holder or pod being in the wrong position. Try repositioning or replacing the coffee pod.
How to fix STEAM output that does not function on Hi-Fly Espresso Coffee Maker?
If the STEAM output on your Hi-Fly Espresso Coffee Maker isn't working, it's likely due to no water supply. Refer to the NO WATER LED corrective action mentioned earlier to resolve this issue.
General| Brand | Hi-Fly Espresso |
|---|---|
| Model | HFE98-28 SERIES |
| Category | Coffee Maker |
| Language | English |
Details on the handle and electrical switches for STEAM, ON/OFF, HOT WATER, and COFFEE CUP functions.
Description of status indicator lights like READY, NO WATER, and others on the control panel.
Tasks to perform daily after each flight, including spout change and cleaning cycles.
Cleaning and potential replacement of the filter cup and filter every three months.
Recommendation to return the unit for preventive maintenance at an authorized station.
To Next Page