Using the host computer
We provide a matching host computer for users to use for evaluation. Different from the direct
observation of the module output through the serial port, the host computer can do some upper-layer
delay processing after receiving the serial port signal output by the module.
After connecting the module, click the serial port detection - serial port selection - open the
serial port, and the display interface will display the current status. Someone moves the
corresponding module serial port mov output.
Enter an integer greater than 1 in the switch static window. When the number of times the
host computer receives occ continuously is greater than the set value, the host computer
displays that someone is in a static state, corresponding to the occ output of the module serial
port. Enter an integer greater than 1 in the switch man status window. When the host
computer enters the man static state, when the number of consecutive move received is greater
than the set value, the host computer displays that there is someone moving.
To Next Page
Loading...