Enter an integer greater than 1 in Toggle Unattended Window, the window unit is seconds.
When the upper computer does not receive any signal longer than the set time, the upper
computer displays the unmanned state.
Click the setting interface, and the sensitivity setting and saving parameters window will
appear. The Sensitivity drop-down menu can select 1-30, 1 is the default sensitivity setting,
and each increase by 1 increases the sensitivity threshold th1/th2 by 10%. The module does
not support flash save temporarily, and the save button of the host computer can be ignored.
Parameters such as sensitivity need to be reconfigured after power failure. The right side of
the window will also display the output signal of the module's serial port.
Note: When performing the setting operation of each window in the upper computer, you need to
click the button to close the serial port of the upper computer. After setting, click to open the
serial port.
To Next Page
Loading...