Data is based on operation of a standard double ended HPS/MH lamp.
Supply power is based on typical commercial 240V,50/60Hz.
Note: When the controller is connected the CONTROL indicator LED ashes 2 times every 2
seconds - indicating controller is functioning correctly. However, if the Connect Link Cable is
removed during operation the ballast will shut down after 3 minutes. When operating
ballast without a HI-PAR Control Station the CONTROL indicator LED will be o. Turn power
o and on to reset the ballast when either connecting or disconnecting the Control Station.
BOX CONTENT:
1 x 1000w Digital Ballast
1 x Power Cord
1 x Connect Link Cable
4 x Rubber Feet
1 x User Manual
1. Digital Ballast
DE lamps ONLY
6. OUTPUT to
HPS or MH lamp
2. Power Cord
3. Magnet Ring
4. Power Input
8. Connect
Link Cable
Performance
Model
HP1000E
Control
Model
Voltage
(V)
Max Input
Power
(W)
Maximum
Current
(A)
Power
Factor
(COSθ)
Working
Voltage
(V)
Ignitor
Voltage
(kV)
240V 1185
THD
<10% 5.0 .97 215-265 4.0
USER MANUAL
HP1000E Control for DE HPS and MH lamps
Installation Directions
5. Rubber Feet
STATUS
LED
Output lock down
Output errors
Low input voltage
Over temperature
High input
1 Flash
2 Flash
3 Flash
4 Flash
5 Flash
MIN
MAINS POWER
1116
1016
761
602
MAX
1185
1085
830
671
BOOST
100%
75%
60%
MIN
LAMP POWER
1066
966
716
566
MAX
1135
1035
785
635
BOOST
100%
75%
60%
7. Dimming Knob
To Next Page
Need help?
General
