Hi-Target HTS-420R - Cogo; Traverse

Total Station Manual
- 103 -
○
4 Move the prism just
standing below the remote
point, then aim at the
bottom of prism rod and
press [F1] (ALL) or [F2] + [F3]
(DIST + REC) to finish the
base point measuring.
[F1] or
[F2]+[F3]
ALL
[Base Pt.]
DIST REC ↓
:
偏置模式 :
Aim and meas. base PT！
4.086 m
Base Pt.:
1
1
EDM Back |←
○
5 Turn the instrument
telescope aimed at prism
and press [F4] to measure
the prism high. Then enter
the [REM PT] window.
[F4]
Back
[Base Pt.]
OK
T.H. :
:
偏置模式 :
Aim and meas. target!
4.086 m
Base Pt.:
1.418 m
305°37′35″
VA :
1
1
○
6 Turn the instrument
telescope aimed at remote
point and press [F4] to finish
current remote point
measuring. Press [F1] to
re-set the base point.
[F4]
Base Pt.
[REM PT]
OK
REM PT :
:
△ :
偏置模式 :
Aim and meas. target!
2.430 m
Base Pt.:
4.082 m
1
Z :
2
3.849 m
1
11. COGO
COGO（Coordinate Geometry）is an application used to perform coordinate
geometry calculations by the preset conditions such as , coordinates of points,
bearings between points and distance between points.
The COGO calculation methods include:
 Inverse and Traverse
 Intersections
 Offset
 Extension
11.1 Traverse
Use the traverse subapplication to calculate the plane coordinate of a new
pointusing the bearing and distance from a known point. Offset is optional.