Hi-Target HTS-420R - Page 124

Total Station Manual
- 123 -
○
2 Set the start point
and end point.
※There are four ways
to get the known
point for Set Point
calculation. Please
refer to the step
○
2 in the “COGO
Traverse”.
Set known
points
Meas.
[Get Side PT]
Result Find ↓
偏置模式 :
8
Define baseline!
PT1 ：
PT2 ： 9
EndW.OS.： 0.000 m
Transverse： 0.000 m
Input Length&Trav.!
○
3 Then baseline is
defined, press [▼] key
to move the focus
down and input the
longitudinal and offset
distance.
[▼]
+
Input
distance
Meas.
[Get Side PT]
Result Find ↓
偏置模式 :
1.265 m
Define baseline!
PT1 ： 8
PT2 ： 9
EndW.OS.：
Transverse： 2.345 m
Input Length&Trav.!
○
4 When all of the
data are set correctly,
press [F2](Result) to
calculate the
intersection point and
show the results.
Input the name of
result point in the
[SetPT Result] and
press [F4](REC) to save
the point.
[F2]
[SetPT--Result]
REC
Pt. ： 10
N ： 6.369 m
E ： 10.536 m
※ In all of the above operation, press [ESC] to return to the previousmenu.
※ The result point is plane data.