Hi-Target HTS-420R - Searching for Fix Points

Total Station Manual
- 146 -
2.1 Search Fix Pt.
Input the name of point or “*” to view the fixpoints in the selected job.
Steps
Key
Display
○
1 In the intertface of View
FixPoint, pressing [F1] (Find)
to enter the function of
finding fixpoints.
[F1]
[View FixPoint]
Job : JOB1
Pt. :
N : 1.000 m
E : 1.000 m
Z : 1.000 m
Find New Edit
6
○
2 There appears a dialog as
shown in the picture on the
right. Input the name of
point or the wildcard of “*”,
press [ENT] to make sure and
press [F4] (OK) to find.
[ENT]
+
[F4]
1
View
[Find]
Job :
Pt. :
JOB1
○
3 Displaying the dialog of
finding result.
If the point exists in the job,
the interface will display the
coordinate information of the
point.
If input the wildcard of “*”,
you can view all fixpoints by
pressing the direction key of
left or right.
[View FixPoint] 1/1
Job : JOB1
Pt. :
N : 1.000 m
E : 1.000 m
Z : 1.000 m
Find New Edit
1