Hi-Target HTS-420R - Adding New Fix Points

Total Station Manual
- 147 -
2.2 Add Fix Pt.
Steps
Key
Display
○
1 In the interface of View
FixPoint, pressing [F2] (New)
to enter the function of
newingfixpoint. If you want to
change the job which need to
new points, you can press
[Job] to select the target job.
[F2]
[View FixPoint]
Job : JOB1
Pt. :
N : 1.000 m
E : 1.000 m
Z : 1.000 m
Find New Edit
6
○
2 There appears a dialog as
shown in the picture on the
right. If want to back to the
previous menu, you can press
[F1] (Back).
[New FixPoint]
Job : JOB1
Pt. :
N :
E :
Z :
Back
OK
○
3 Input the new name and
coordinate of fixpoint, press
[Ent] to finish inputing and
press [F4] (OK) to save the
fixpoint.
If the inputted point name
exists in the memory ， the
program will give a prompt of
whethe to overwrite, press
[F4](Yes) to overwrite or press
[F1](No) to cancle the
operation.
[New FixPoint]
Job : JOB1
Pt. :
N : 100.000 m
E : 100.000 m
Z : 100.000 m
Back
OK
1
PT exists!
If overwrite?
No Yes