Hi-Target HTS-420R - Reflector Type and Prism Constant Settings; Setting the Reflector Type; Setting the Reflecting Prism Constant

Total Station Manual
- 26 -
refer to “Technical Parameters”.
Steps
Key
Display
○
1 After entering to the
interface of EDM Setting,using
the direction of↓ to move
the cursor to the setting item
of Reflector.
↓
[EDM Setting]
EDM Mode: Single
Reflector:
P.C. : -30.0 mm
OK
Prism
ATOMS Pointer
○
2 Press ←→to select the
types of reflector. Each time
you press ←or→，the type of
reflector is switched.
←
→
[EDM Setting]
EDM Mode: Single
Reflector:
P.C. : 0 mm
OK
Non-Prism
ATOMS Pointer
○
3 After finished setting,
press [F3] (OK) to return the
function of Q-Surveying.If you
want to cancel the settings,
press [ESC] to ignore the
changes.
[F3]
1
ALL Code EDM
[Q-Survey] 1/3
Pt. :
T.H. :
Code :
HA :
VA :
:
1.500 m
13°29′59″
90°59′23″
Set up the Reflecting Prism Constant.
As a prism is selected as a reflector, a prism constant should be set before any
measurement. If the constant is entered and set, it is saved and will not be erased
after switching off the instrument.
Example：Prism Constant is -30mm