Hi-Target HTS-420R - Height Transfer Function; Principle of Height Transfer

Total Station Manual
- 46 -
3. NP/P Toggle
Switch the mode of reflector quickly. (P is the mode of Prism and NP is the
mode of Non-Prism)
Set P!
Set NP!
F1
[Function]
F2 F3 F4
F1 Level
F3 NP/P
F4 HT. Transfer
F2 Offset
(1)
(2)
(4)
(3)
【F3】
1/3
Open the first page of Function Menu and press [F3] to switch the mode of reflector.
4. Height Transfer
The functions of HT. Transfer as follows: Using the measurement data of target
point, the fixpoints, fix measurement points and so on to calculate the height of
current station point and set the height of station again. You can receive the
coordinate of target point by calling the points in the file or through the keyboard to
input, you can observe 5 fixpoints’ height at most and to calculate.
The principle of Height Transfer:
P1
P2
P3
P0
P0 Station point
P1~P3 Target fixpoints height