Hi-Target HTS-420R - Settings Configuration; Unit Settings Configuration; Main Instrument Settings

Total Station Manual
- 53 -
9. Unit Setting
Set the common Unit fastly.
Reset
Angle Unit ：
OK
Dist. Unit ：
Temp. Unit ：
Press. Unit ：
F1
[Function]
F2 F3
F1 Unit Setting
F3 EDM Tracking
F2 Main Setting
(9)
(01)
(02)
°′″
Meter
℃
hPA
【F1】
3/3
Open the third page of Function Menu and press [F1] to enter the interface of
unit setting. After finishing setting the units in the interface of Unit Setting, press [F4]
（OK） to save the settings,press [F1]（Reset）to restore all units to factory default.
10. Main Setting
Open the settings about instrument’s hardware, the specific items as follows:
Reset
Light ：
Contrast ：
Trigger Key ：
User Key1 ：
User Key2 ：
Tilt ：
Sector Beep ：
F1
[Function]
F2 F3
F1 Unit Setting
F3 EDM Tracking
F2 Main Setting
(9)
(01)
(02)
【F2】
Off
High
DIST
NP/P
Off
OK
4
Level
3/3
As for the setting of specific items , please refer to “General Setting”.