Hi-Target HTS-420R - Application Overview; Pre-Application Setup; Job Management

Total Station Manual
- 55 -
5. Applications
Prepare setting before measuring:
Before startingthe application, there are some preparations needed to set up.
The Pre-Settingsscreenwill beshown after the user selects an application. User can
select and set the content of the Pre-Settings menu successively.
[Surveying]
[*] F1 Set Job (1)
[ ] F2 Set STA (2)
[ ] F3 Set B.S. (3)
F4 Start (4)
F1 F2 F3 F4
[*]：Setting has been done.
[ ]：Setting has not been done.
The details of every setting are as follows.
1. Setting the Job
The measured data and fix data are saved in the jobs which are shown as
childdirectories. The job contains different types of data, such as fix points, measured
points, station points, codes, etc. The datas in the job can be read, edited and
deleted.
1.1 Create a new Job
Steps
Key
Display
○
1 Press [F1] in the
Pre-Settings screen. Then
enter the Set Job function.
[F1]
[Surveying]
[*] F1 Set Job (1)
[ ] F2 Set STA (2)
[ ] F3 Set B.S. (3)
F4 Start (4)
F1 F2 F3 F4