Hi-Target HTS-420R - Selecting an Existing Job

Total Station Manual
- 57 -
[Surveying]
[*] F1 Set Job (1)
[ ] F2 Set STA (2)
[ ] F3 Set B.S. (3)
F4 Start (4)
F1 F2 F3 F4
※
1
：The instrumentsystem will create and add date and time automatically.
1.2 Select anExisting Job from Memory
If there is any job existing in the memory, user can select this job and set it as
the current job.
Steps
Key
Display
○
1 Press [F1] in the
Pre-Settings screen. Then
enter the Set Job function.
[F1]
[Surveying]
[*] F1 Set Job (1)
[ ] F2 Set STA (2)
[ ] F3 Set B.S. (3)
F4 Start (4)
F1 F2 F3 F4
○
2 Press [F1] (List) to enter
Job list screen.
[F1]
[Set Job]
Job : DEFAULT
Operator:
Date : 20150515
Time : 14:10:20
List New OK
○
3 All the existing jobs,
including that stored on SD
Card and will be shown as a
list. The current job is marked
with a *. Select the target job
through Up and Down key and
then press [F4](OK) to confirm
the selection. The selected job
[Job list]
JOB1
JOB2
JOB3
JOB4 [SD]
New View OK
Delete