Hi-Target HTS-420R - Station Setup Procedures

Total Station Manual
- 58 -
is set as current job.
○
5 Back to Pre-Setting
screen.The completed setting
item is marked with *.
[F4]
[Surveying]
[*] F1 Set Job (1)
[ ] F2 Set STA (2)
[ ] F3 Set B.S. (3)
F4 Start (4)
F1 F2 F3 F4
Note:Don’t pull out the SDCard when it is in operating state, otherwise it will cause
the SDCard’sdata loss or damage.
 All measureddatas are stored in the current job.
 If start the application without setting the job, press ALL key or press REC key in
the Q-Surveying screen, the instrument system will create a job which named
DEFAULT automatically.
2. Setting the Station
Every target coordinate's calculation is related to the position of the station. The
station coordinate can be input manually or selected from the instrument memory.