Hi-Target HTS-420R - Selecting Station Coordinates from Memory

Total Station Manual
- 59 -
2.1 Select the coordinate from memory [Find]
Steps：
1、 Select the coordinate from memory.
2、 Input instrument height.
3、 [OK] Set station.
Steps
Key
Display
○
1 Press [F2] in the Pre-Settings
screen. Then enter the Set STA
function.
[F2]
[Surveying]
[*] F1 Set Job (1)
[ ] F2 Set STA (2)
[ ] F3 Set B.S. (3)
F4 Start (4)
F1 F2 F3 F4
○
2 Input the name of the
station point which exists in the
job and then press [ENT]. ※
1
Input
point
name
+
[ENT]
[Set STA]
Input STA PT!
Station :
A1
Find List
Coord.
○
3 Press [F1](Find):
A: If the input name exists in
the current job, there will show
the screenas shown on the right
figure. The multiple points with
the same name will be sorted
by type.
B: If the input name doesn’t
exist in the current job, the
program prompts the message
“Pt. not found”. Then enter the
[Find Pt.] screen.
There can also select point from
other jobs and set it as the
station point. Input the point
A：
[Find Pt.] 1/5
1 Station
View Job OK
A1 Station
A1 Meas. PT
A1 Meas. PT
A1 Target PT
Coord.
B：
121
Job Zero Find
[Find Pt.]
Job :
Pt. :
DEFAULT
Select job or input coord.!
Coord.