Hi-Target HTS-420R - Setting Instrument Orientation; Manual Orientation Input

Total Station Manual
- 63 -
○
4 Press [F4](OK) to save
the coordinates of this
point.
[F4]
[Input Coord.]
Job : DEFAULT
Pt. :
N :
E : 15.012 m
Z : 4.215 m
Back OK
121
3.102 m
○
5 Program
prompts"Saved!" Then enter
input instrument height
screen. Input the instrument
height and press [ENT] to
confirm. Then press [F4](OK)
to finish the setting.
Input
instrument
height
+
[ENT]
[F4]
[Set STA]
Input I.H!
IH. :
1.400 m
Back OK
○
6 Back to Pre-Settings
screen. The setting items
that have been made are
marked with *.
[Surveying]
[*] F1 Set Job (1)
[*] F2 Set STA (2)
[ ] F3 Set B.S. (3)
F4 Start (4)
F1 F2 F3 F4
3. Setting the Orientation
The orientation can be input manually or determined from points that are either
measured orselected from the memory.
3.1 Manual input orientation
Steps：
1. Press [F1] and enter manual input screen.
2. Input the azimuth, prism height and point name.
3. Press [F1](ALL) to start measuring and set theorientation.
4. Press [REC] to record theangle and orientation.