Hi-Target HTS-420R - Orientation Setup Using Coordinates

Total Station Manual
- 65 -
3.2 Set orientation with coordinates
The determination of the direction value can also be carried out using a point
with a known coordinate.
Steps：
1. Press [F2] to go to set orientation with coordinates
2. Input the name of orientation point and find the point.
3. Input the prism height and determine it.
4. Use this point to set orientation.
 The orientation point can be select from memory or inputted manually.
Steps
Key
Display
○
1 Press [F2] to select
Coordinate to Set orientation
with coordinates.
[F2]
[Set B.S.]
F1 Angle Setting (1)
F2 Coordinates (2)
F1 F2
○
2 Find, select or input the
backsight point coordinates
and then go to the Meas. BS
screen.
Find,
select or
input the
backsight
point
[Set BS]
Input BS PT!
BS PT :
DEFAULT1
Find List
Coord.
○
3 Aim backsight point and
then press [ENT].
Press [F1](ALL) or press
[F2](DIST) and [F3](REC) to
start measuring and finish
setting orientation. User can
also press [F3](REC) to finish
setting orientation without
measurement.
[ENT]
[F1]
or
[F2]、[F3]
Meas. BS
BS PT : DEFAULT1
T.H. : 1.400 m
HA :
Azimut :
:
1.500
ALL DIST REC EDM
45°00′00″
Aim BS PT!
Press ENT continue