○
3 After inputting the target
point’s name or wildcard (*),
press [ENT] and then press
[F4](View) to look over the
datas. If there is no match
point, the program
prompts“Pt. not found!”
[Job]: Select the job where the
measureddatais to be viewed.
○
4 Go to View Measured
Point screen. Press [PAGE] to
turn the page and look over all
data field of this point. Press
direction key ← and → to
browse the last or next
measured point.
[Delete]: Delete this point
data.
[Search]: Back to the Find
Point screen.
To Next Page
Loading...
