○
8 Now itfinishes staking out
a point.Repeat the previous
steps to stake out next point.
6.3 Orthogonal to StationStakeout Mode
Use longitudinal difference and perpendicular difference to indicatethe position
differences of stakeout point and current prism position.
The meanings of the differencesin theOrthogonal to StationStakeout Mode:
△Length Difference in longitudinal distance: If the measured point is farther
than stakeout point, the value is positive.
△Trav. Difference in perpendicular distance: If the measured point is located
in the right side of stakeout point, the value is positive.
○
1 Press [PAGE] to show
Orthogonal to StationStakeout
Mode in page 2/3. Set the
stakeout point. The stakeout
point can be found in the job
through inputting point name
in the search item.
To Next Page
Loading...
