Hi-Target HTS-420R - Resection

Total Station Manual
- 88 -
7. Resection
Resection measurement is an application used to determine the coordinate of
the instrument station by measuring multiple known points. A minimum of 2 and a
maximum of 5 known points can be used to determine the station. It should be used
at least 2 known points by distance measurement or at least 3 known points by angle
measurement.
Steps
Key
Display
○
1 Select “Program” from
the [Main Menu] window,
press [F3] or number key [3]
to enter the Resection
application.
[F3]
[Program] 1/2
F1 F2 F3 F4
F1 Surveying (1)
F2 Stakeout (2)
F3 Resection (3)
F4 Tie Distance (4)
○
2 Press [F1] in the
[Resection] window to set the
job.
[F1]
[Resection]
[ ] F1 Set Job
F2 Set Error Limits
F4 Start
F1 F2 F4
○
3 In [Set Job] window, press
[F1] (List) to select a job in
memory or press [F2] (New)
to new a job. Then press [F4]
(OK) to next step.
[F4]
[Set Job]
Job : DEFAULT
Operator:
Date : 20150515
Time : 14:10:20
List New OK
○
4 The window back to the
[Resection] window, and
press [F2] to set error limits.
[F2]
0.000 m
OK
[Set Error Limits]
e(Y/E) :
e(X/N) :
e(Z/H) :
0.000 m
0.000 m
Input error limits!
Off
Status :