V60 GNSS RTK System Operation Instruction
Key Functions
V60 GNSS RTK system can on or off LCD panel display through
double clicking power key. High-definition LCD panel can
complete the basic requirements of receiver with two keys, which
also can flexibly set three work modes, base, rover and static mode.
The key operation of control panel is specified as follows:
LCD coordinates key operation
Double click the power key and start the LCD; the initial interface
will display current work mode and relevant basic information.
Figure 3-5
Solution state
Working mode
Difference age
Shared Satellites - Visible Satellites
Remaining power of host
Data link form
PDOP value
Signal enhancement value
Host firmware version:
23
To Next Page
Loading...
