Hi-Target ZTS-320 Series - Area

71
3. Press soft key „Meas‟ to start measurement. After the
measurement, the „HR‟‟SD‟‟VD‟are displayed on each column.
Press soft key „Enter‟ to accept the measurement. If accepting,
soft keys „Next‟ and „Calc‟ will appear on the screen. Press „Next‟
to define and measure the second point (Coord.Z-No.2),
otherwise press „Calc‟ to enter „Coord.Z-Result‟ page.
Then you may use „SetZ‟ to set the z coordinate of the station.
You may also use soft key „Set A‟ to set the BBS of the instrument.
Press „ESC‟ to quit coordinate measurement.
9.4.5 Area
This function is to help you to calculate out the area of the
plane figure formed by measured or inputted coordinates.
1. Enter the interface of„Survey(Area)‟
2.Press soft key „Input‟ to call coordinates from coordinate
file or input the coordinates manually with keyboard .The
coordinates are all listed in the screen and the maximum number
of points when Area Surveying is 20.
The inputted or measured coordinate is inserted below the
indicator column, which determine the shape of the formed area.
3.The area enclosed is the connection of line from the begin
to the end (begin) one by one in order. Thus, you may not get the
Survey(Area)
Pt01: 2500.000 75.000
Input Meas Del
Coord.Z-Result
BSA: 170°12′23″
Z: 1.234
dZ: 0.001m
SetZ
Coord.Z-No.1
HR: 77°34′50″
SD:
HD: m
VD:
Meas Mode Enter