To Next PageTo Next Page
Need help?Do you have a question about the Hi-Velocity HE Series and is the answer not in the manual?
Overview of components and system features.
Details on the straightforward installation process.
Discusses heating, cooling, and air quality functions.
Standards and compliance for the system components.
Warranty details, terms, conditions, and manufacturer liabilities.
Notes on product changes, specifications, and illustrations.
Prerequisites and considerations before installing outlets.
Guidelines for installing and properly locating vents for optimal comfort.
Steps for installing rough-in boots and vents in kick spaces.
Guidance on placing the fan coil unit for optimal installation.
Required spacing around the fan coil for access and servicing.
Instructions for suspending the fan coil unit, including strap kit usage.
Guidelines for installing the main plenum, including placement, connections, and structural integration.
Details on using flexible duct, branch take-offs, and making secure connections.
Procedures for installing various types of outlets, including retrofits and special grills.
General guidelines for designing and installing return air systems.
Procedures for sizing return air ducts and cutting fan coil knockouts.
Information on the return air base, filter, and mounting additional components.
Introduction to the EPC circuit board, motor, and control board.
Provides wiring diagrams, 24V controls, and factory dip settings.
Standard and metric airflow data based on dip switch settings.
How to adjust CFM output using EPC dip settings for fine-tuning.
Introduction to the RPM-E refrigerant cooling module.
Covers configurations, mounting, drain connections, and piping.
Procedures for evacuation, charging, heat pumps, bi-flow receivers, and freeze stats.
Diagnosing TXV issues and common causes of short cycling.
Introduction to the WCM/WM chilled water coil add-on module.
Steps for installing and piping the chilled water coil.
Introduction to the HWC hot water coil add-on module.
Steps for installing and piping the hot water coil.
Introduction to the Electrical Strip Heater unit.
Procedures for installing and wiring the ESH unit.
Covers operation, maintenance, zoning, and provides wiring diagrams.
Details on optional wiring for staging and fan speed control.
Details on the optional filter rack and Hi-Velocity Air Purification System.
Information on PWM Zoning Controller and Turbo Meter.
Covers fresh air make-up, fire stopping, humidity control, and HRV/ERV integration.
A comprehensive checklist to ensure proper system installation.
Steps to diagnose EPC motor and low airflow issues.
Diagnosing 24-volt wiring and circuit board problems.
Diagnosing outdoor unit electrical issues and short cycling problems.
Technical specifications for various coils and fan coil units.
A quick reference guide for unit dimensions and sizing parameters.
Fields for collecting job details, system parameters, and ductwork configuration.
Sections for recording performance data for heating, cooling, refrigerant, and airflow.
General| Fuel Type | Natural Gas or Propane |
|---|---|
| Heating Capacity | 40, 000 to 120, 000 BTU/h |
| Heating Stages | Two-Stage |
| Blower Motor | ECM motor |
| Heat Exchanger | Stainless steel |
| Voltage | 115V |
