6
TROUBLESHOOTING GUIDE
Technical Data
• 100g ground coffee jug capacity;
• 40mm Stainless steel conical burr;
• 210g coffee bean holder capacity;
• 200W powerful motor;
NOTICE: Regular cleaning helps the burr achieve consistent grinding results, which is especially important.
Run Grinder Until Empty Remove Bean Box Remove Upper Burr
Clean Upper Burr with
Cleaning Brush
Clean Bottom Burr with
Cleaning Brush
Push Upper Burr Firmly
into Position
Align Bean Box into
Position
Lock Bean Box
Code in display Problem description Solution
E1
No bean holder or bean holder is not connected
tightly.
Assemble the bean holder or tighten the bean holder
until the micro switch is closed. Once the bean holder
is closed, the error code E1 in display disappears.
E2
Total operating is 10 cycles, it powers off
automatically to protect the unit.
Motor is overheating.
The air blower does not match the bean box.
The bean box can not be installed.
Coffee outlet get clogged
Unplug the power cord, then wait for the motor to
cool down for over 30 minutes and restart.
Turn the air blower up side down, then install again.
Make sure the "STOP" mark is aligned with the
calibration mark " I ".
Clean with the air blower after each use.
The grinding size is too fine or too coarse Clean the the upper burr part
To Next Page
Loading...