EN
ENGLISH
WELCOME
Thank you for choosing our Coffee Machine.
In this manual you will find the instructions, warnings and recommendations necessary to enjoy our product safely and satisfactorily. Before connecting your
machine, take the time to read the safety precautions carefully.
PARTS LIST
O
O
O
ABOUT THIS MANUAL
O
O
Coffee Powder E.S.E POD
Opening leverfor changingthe adapters.
2. Compartment for the adapters.
Small cup support.
4. Large cup support.
5. Control buttons: On/off, short coffee and long coffee.
6. Water tank lid.
. Water tank.
_ Adapterfor Nespresso@•capsules.
Adapterfor Dolce
10. Adapterfor groundcoffee or ES E pod (44 mm)
* Nespresso g Dolce Gusto are trademarks
of Societedes Produits Nestle SA
This instruction manual cannot cover all possible circumstances. Incase of doubts or problems not adequately described in this operating manual, you can obtain
more information by contacting the CustomerService Department.
Please keep this instruction manual for reference if necessary.
UNPACKING
1_ Removeyourcoffee machine from its packaging.
2. After unpacking, verify that the following parts are included:
• Water tank
• Coffee maker
• Manual
• Adapters
Note:
• Verify that the voltage of the electrical current in your home or establishment is the same as that stated on the nameplate of the machine.
• Recycle all plastic bags to avoid hazards to children!
• Keepthe packaging for transporting the machine (e.g. for disassembly, repair,etc.).
GETTING STARTED
Beforeusingyourcoffeemakerforthe firsttime,payattentionto the safetyprecautionsinthis manual,in particularthe following:
• Becareful with the hot water! You could get burnt
• Rinsethe water tank thoroughly with clean water before the first use.
• Do not operatethe unit with an empty water tank or if the water level is below the minimum level.
• Only use the appliance in a dry room.
• Do not open the lever when the machine is warming up or running.
• Always unplug the power cord before cleaning the machine.
• Cleanthe coffee maker only with a damp cloth.
The first step is to fill the water tank; there are two ways to do this:
Fill without removing the tank.
1. Lift the water tank cover.
2. Fill the tank with clean water (maximum water temperature 35'C)_
3. Lower the tank cover.
Fill by removing the water tank.
1. Slightly lift the water tank in the direction shown in the picture to remove
the water tank from the appliance. Fill the tank to the TAX" line with
cleanwater(maximumcapacity litres).
2. Slowly slide the water tank over the base of the water tank, performing
the reverse procedure described above. When the water tank outlet is
inserted into the inlet base, push down to lock the water tank.
2
o
To Next Page
Loading...