EN
Before using for the first time or after long pauses (e g holidays) the machine may be difficult to pump
water, this short procedure can help pump to self priming by using the pipe to fill water into the circuit
manually prior to turn on the machine for first refill.
Step 1# :insert the pipe into
the water entrance
Step 2# :fill water into
the pipe
Step 3# : inject the water
from pipe into the machine
so that the internal circuit
is filled with water.
After above Steps, the machine will be able to pump water out normally.
* If necessary, repeat the Steps for 2 or 3 times.
8
To Previous Page
Loading...