press the pump control switch, maker sure the coffee/steam selector , when
there is water flowing out and close the pump, and wait for a moment, the
coffee maker begins to be heated.
When the lamp in pump control switch is illuminated, it shows the heating is
finished. Pressing the pump control switch and make two cups coffee (about
20z). Then close the pump and wait for 5s.
Press the coffee/steam selector, the indicator in the pump control switch will
be extinguished, waiting for until the indicator in the coffee/steam selector is
illuminated. Make steam for 2min by turning the steam control knob, then
turn the steam control knob to “o” position to stop making steam. Press the
Power switch for stop the unit immediately, make the descalers deposit in
the unit at least 15 minutes.
Restart the unit and repeat the steps of 4-6 at least 3 times.
Then press the coffee/steam selector , the lamp in pump control switch will
be illuminated, then press the pump control switch to brew until no descaler
is left.
Then brew coffee (no coffee powder) with tap water in the MAX level, repeat
the steps of 4-6 for 3 times (it is unnecessary to wait for 15 minutes in step of
6), then brew until no water is left in the tank.
Repeat the step of 9 at least 3 times to make sure the piping is clean.
5.
6.
7.
8.
9.
10.
TROUBLE SHOOTING
Symptom Cause Corrections
The metal parts in the
tank have rust.
The descaler is not recom-
mended type. It may
corrode the metal parts in
the tank.
Use the descaler recom-
mended by manufacturer.
Water leaks from the
bottom of coffeemaker.
Water leaks out of outer
side of filter.
There is much water in the
drip tray
Please clean the drip tray.
The coffee maker is
malfunction.
There is some coffee
powder on filter edge.
Get rid of them.
Please contact with the
authorized service facility
for repairing.
01 02 03 04 05 06 07 08 09
To Next Page
Loading...