Troubleshooting
malfunction
The espresso function does not
work AND/OR the espresso
function stops unexpectedly
AND/OR froth comes out of the
spouts of the portafilter.
cause
This may happen just after
switching on the appliance or
after using the steam function.
During extraction, you switched
to the steam or hot water
function.
The water thank is empty.
The grind size is too fine.
The coffee powder is tamped
too firmly.
The water system strongly
requires descaling.
The pores of the filter basket
are clogged.
solution
The water system needs to reach
the extraction temperature,
before an extraction can be
started. Wait until the espresso
icons illuminate, before
attempting to start an extraction.
The extraction will be terminated
at once, when another function is
activated.
Fill a sufficient amount of water
into the water tank. Always
ensure that the filling level in the
water tank is between the •MIN"
and •MAXI' making, before
starting any function of the
machine.
Only use coffee powder that is
suited for espresso machines. It
is recommended to select the
12-15 grade when grinding the
espresso powder
Do not apply too much force,
when tamping the coffee powder
(12--13kg)
Always descale the water system
in time . If the water hardness of
your tap water is extremely high,
use non-carbonated, low-mineral
table water.
Thoroughly clean the filter
basket. If required, use the
needle tool for opening the pores
of the filter basket.
EN
\ 16
To Next Page
Loading...