HID Fargo DTC5500LMX - Calibrate Ribbon Tab

To o l Box Page 4-4
PLT-02496, Version: 1.0 November 2015
4.3 Calibrate Ribbon Tab
To Calibrate the Ribbon:
1. Take out the ribbon drawer and remove the ribbon.
2. Reinsert the empty ribbon drawer.
3. Click Calibrate.
4. After calibration has completed, take out the ribbon drawer and reinstall the ribbon. Reinsert
the ribbon drawer into the printer.
5. The printer will beep twice if the procedure was successful, once if the procedure failed.
6. Click the OK button to complete the procedure.
Note: Calibration may also be performed from the printer LCD. See Section 3.10.2: Sensor
Calibration Options.