30 September 2018
Setup and installation PLT-02931, Rev. A.0
2.8 Printer power
Important: Do not connect the printer USB cable until prompted during the printer driver installation.
To connect power to the printer:
1. Plug the power cable into the back of the printer.
2. Plug the wall power cable into a standard 100-240 VAC power outlet.
3. Switch on the printer.
Note: If the physical switch is left on and the printer is left idle, the printer enters a low power state.
When a print job is sent, the printer restores full power and the print job commences.
Important: If connecting by Ethernet, add the ferrite (supplied with the printer) before plugging in the
Ethernet cable.
To Next Page
Loading...
