HID FARGO HDP 6600 - Page 112

Printer Display Error Message Cause Solution
Headlift Error
Error Message No. 436, 437, 442, 443
This is a problem with the printhead lift. Reset the printer and try again.
If this problem persists, call for technical
assistance.
Heater Error
Error Message No. 551, 557
The transfer heater roller is too hot. Reset the printer and try again.
If this problem persists, call for technical
assistance.
Invalid Ribbon
Error Message No. 519
An unauthorized ribbon is installed in the
printer.
Get the correct ribbon from your dealer.
Headlift Error
Error Message No. 553, 554, 555, 556
There is a problem with the transfer roller
headlift.
Reset the printer and try again. If problem
persists, call for technical assistance.
Headlift Error
Error Message No. 560
There is a problem with the transfer roller
headlift.
Reset the printer and try again. If problem
persists, call for technical assistance.
Job Data Error
Error Message No. 544
The print data sent to the printer is corrupt
or has been interrupted.
Reset the printer and try again.
If this problem persists, call for technical
assistance.
Mag Verify Error
Error Message No. 487
Printer could not verify mag write.
OR
The magnetic stripe was not encoded
properly.
Check the cards for correct mag stripe
orientation and try again. Verify the mag
coercivity selection in the driver matches that
of the cards
Multiple Feed
Error Message No. 475
Multiple cards were fed into the printer. Remove all cards and try again.
No E-card Encoder
Error Message No. 451
You are trying to send encoding data, but
the printer is not configured with this
encoder type.
To cancel, press Cancel Print.
No Film
Error Message No. 492
Film is not installed in the printer.
OR
Film RFID tag is bad.
Install the film and press Resume.
To cancel the print, press Cancel on the
printer display or click Cancel Print from the
HID Printer Status Monitor.
No Flip Module
Error Message No. 482
Two-sided job sent to a one-sided printer. Using the printer display, verify the printer
has flipper capabilities.
If flipper capabilities are present, ensure that
the Print Both Sidesoption in the printer
driver is set correctly.
Press Resumeon the printer display to
continue printing.
To cancel the print, click Cancel Printfrom
the HID Printer Status Monitor.
No Mag Module
Error Message No. 486
Mag encoding job sent to the printer
without a mag encoder.
You are trying to send encoding data, but
the printer is not configured with this
encoder type.
To cancel the print, click Cancel Printfrom
the HID Printer Status Monitor.
PLT-02931, A.4 112 November 2021
Powering
Trusted Identities
FARGO® HDP®6600 High Definition Card Printer/Encoder
User Guide