HID FARGO HDP 6600 - Page 79

Setting Description
Transfer EOF Print the alignment self-test card.
Setting the Transfer EOF to a positive number causes the image length to grow.
Setting the Transfer EOFto a negative number causes the image length to shorten.
Transfer Temp Offset Both the printer and the printer software driver control the built-in transfer roller.
To change the temperature of the transfer roller, adjust the temperature through the Image Transferselection
within the Advancedtab of the printer preferences. Once adjusted, the new temperature setting is sent down
with the next print job along with the rest of the printer driver information.
Before printing begins, the transfer roller automatically adjusts to the new temperature setting. This new
temperature setting remains programmed within the printer until it is once again changed within the printer
driver or until the printer is turned off.
Whenever the printer is turned OFF, the transfer roller automatically resets and returns to the default
temperature the next time the printer is turned ON.
Disconnect the printer power supply.
Technician Note:Cycling the printer power supply serves to reset the transfer roller to its default temperature.
The temperature setting within the printer driver, however stays the same until it is changed.
DANGER: THE PRINTER TRANSFER ROLLER CAN REACH TEMPERATURES EXCEEDING 350°F (175°C).
USE EXTREME CAUTION WHEN OPERATING THE TRANSFER ROLLER. NEVER TOUCH THE
TRANSFER ROLLER UNLESS THE PRINTER POWER HAS BEEN TURNED OFF FOR AT LEAST 20
MINUTES.
DANGER: LE ROULEAU DE TRANSFERT DE L'IMPRIMANTE PEUT ATTEINDRE DES TEMPÉRATURES
SUPÉRIEURES À 350°F (175°C). SOYEZ EXTRÊMEMENT PRUDENT LORSQUE VOUS UTILISEZ
LE ROULEAU DE TRANSFERT. NE TOUCHEZ JAMAIS LE ROULEAU DE TRANSFERT À MOINS
QUE L'ALIMENTATION DE L'IMPRIMANTE A ÉTÉ ÉTEINT PENDANT AU MOINS 20 MINUTES.
Encoder Flip Angle Use this setting to fine tune the position of the flipper.
Only used if encoder is present.
Print Flip Angle Use this setting to fine tune the home position of the flipper if cards have difficulty moving from the printer
into the flipper.
Print Flip Level Use this option to set the position of the flipper so it is level with the card path after a flip operation.
PLT-02931, A.4 79 November 2021
Powering
Trusted Identities
FARGO® HDP®6600 High Definition Card Printer/Encoder
User Guide