16 17
EN EN
Using the appliance Using the appliance
B B
Secondary functions
The table that summarises the options that can be selected in the programs is given below.
Option Description
Anti-crease
If you select the "Anti-crease" option and do not open the door at the
end of the program, the Anti-Crease phase scheduled for 1 hour will
take 2 hours. After selecting the Anti-Crease option, you will hear
an audible warning signal. You can press the same button again to
cancel this option. If you open the door or press the Start/Pause
button while the anti-crease process is still in progress, this step
will be cancelled.
Delaying the start
You can delay the start time of the program by selecting the 3 hours, 6
hours or 9 hours option. You can enable the required delay by pressing
the On/O button. When the time comes, the selected program starts
automatically. During the time delay, the options that are compatible
with the program can be enabled/disabled.
Cancel the warning
sound
The dryer emits an audible warning when you turn the program
selection button and when you press the buttons at the end of the
program. To cancel these warnings, press and hold the "Delicate
Drying Option" button for 3 seconds. If you press this button, you will
hear a warning sound indicating that the option has been cancelled.
Option Description
Child lock
There is a child lock option to prevent changes to the program
when buttons are pressed during the program. To enable the child
lock, the user must press and hold the "Delay Timer" and "Anti-
crease" buttons at the same time for 3 seconds. When the child
lock is enabled, all the buttons are disabled. The child lock is not
automatically disabled at the end of the program. To disable the child
lock at the end of the program, turn the program selection button
to the "O" position. Then, turn the program selection button to the
rst position. The child lock stays active. To disable the child lock,
the user must press and hold the "Delay timer" and "Anti-crease"
buttons at the same time for 3 seconds. When you enable/disable
the child lock, the "Anti-crease" option light ashes and an audible
signal sounds. Warning: if you turn the program selection button
when the product is running or the child lock is enabled, you will hear
an audible warning. Even if you set the program selection button to
another program, the previously selected program will continue to
run. To select a new program, you must disable the child lock before
resetting the program selection button.
To Next Page
Loading...
