HIKVISION ADS-24S-12 1224GPCN - Set Video and Audio Parameters

Note
6 to 12 leers (a to z, A to Z) or numbers (0 to 9), case sensive. You are recommended to use a
combinaon of no less than 8 leers or numbers.
5.
Click Save to enable the sengs.
Device Access Seng
Steps
1.
Click
Conguraon → Network → Device Access → SIP to enter the sengs page.
2.
Check Enable VOIP Gateway.
3.
Congure the SIP parameters.
4.
Click Save to enable the
sengs.
5.
Click Conguraon → Network → Device Access → SDK Server to enter the sengs page.
6.
Set the Server Port. It refers to the port through which the client adds the device.
8.6.9 Set Video and Audio Parameters
Set the image quality and resoluon.
Set Video Parameters
Click Conguraon → Video/Audio → Video .
Figure 8-5 Video Sengs Page
Set the stream type, the video type, the resoluon, the bitrate type, the video quality, the frame
rate, the Max. bitrate, the video encoding, and I Frame Interval.
Click Save to save the
sengs aer the conguraon.
Video Intercom Villa Door Staon User Manual
53