HIKVISION DS-2TD6267-75C4L/WY - Set VCA Parameters; Configure the Perimeter Protection

6.2 Set VCA Parameters
Steps
1.
Go to Conguraon → Local .
Rules
Enable it to display rules informaon on live view.
Display Rules Info. on Capture
Select Yes to display rules
informaon on the capture.
2.
Go to Conguraon → VCA .
3.
Select the camera channel.
4.
Go to Basic
Sengs to congure VCA parameters for the channel.
Display VCA Info. on Stream
Select to display target info and rule on stream, the informaon will be added to the video
stream, and the overlay will be displayed if you get live view or play back by the VS Player.
Display Target Info. on Alarm Picture
Select to display the target
informaon on the alarm picture.
Display Rule Info. on Alarm Picture
Select to display the rule informaon on the alarm picture.
Snapshot Sengs
Select to upload the picture to the surveillance center when the VCA alarm occurs. You can
also set the quality of the picture.
5.
Click Save.
6.3
Congure the Perimeter Protecon
This secon is the detailed instrucon of conguring the perimeter protecon rules.
Steps
1.
Go to Conguraon → VCA , and select a camera channel to start conguraon.
2.
Refer to Set Detecon Scenes and Tracking for detecon scene and tracking sengs.
3.
Refer to Set Rules to set the scene rules.
4.
Refer to Set the Scene Auto-Switch for seng scene patrol.
5.
Go to
Conguraon → VCA → Camera 02 → Basic Sengs , enable Intelligent Analysis.
6.
Click Save.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
29