HIKVISION DS-2XS6A87G1-LS/4G - Set Region Entrance Detection

Figure 10-2 Set Rule
6.
Oponal: You can set the parameters of mulple areas by repeang the above steps.
7.
For the arming schedule sengs, refer to Set Arming Schedule . For the linkage method sengs,
refer to Linkage Method Sengs .
8.
Click Save.
10.3.3 Set Region Entrance
Detecon
It is used to detect objects entering a predened virtual region from the outside place. If it occurs,
the device can take linkage
acons.
Before You Start
●
For certain device models, you need to enable the smart event
funcon on VCA Resource page
rst.
●
For the device supporng HEOP, go to VCA → APP to import and enable Smart Event.
Steps
1.
Go to VCA → Smart Event → Region Entrance Detecon . For certain device models, you should
go to Conguraon → Event → Smart Event → Region Entrance Detecon .
2.
Check Enable.
3.
Select a Region. For the
detecon region sengs, refer to Draw Area .
4.
Set the minimum size and the maximum size for the target to improve
detecon accuracy. Only
targets whose size are between the maximum size and the minimum size trigger the detecon.
For the detail sengs, refer to Set Size Filter .
5.
Set the detecon target, sensivity and the target validity.
Sensivity
It stands for the percentage of the body part of an acceptable target that goes across the
predened region. Sensivity = 100 - S1/ST × 100. S1 stands for the target body part that goes
across the predened region. ST stands for the complete target body. The higher the value of
sensivity is, the more easily the alarm can be triggered.
Network Camera User Manual
92