HIKVISION DS-2XS6A87G1-LS/4G - Set Object Removal Detection

Figure 10-5 Set Rule
6.
Oponal: You can set the parameters of mulple areas by repeang the above steps.
7.
For the arming schedule sengs, refer to Set Arming Schedule . For the linkage method sengs,
refer to Linkage Method Sengs .
8.
Click Save.
10.3.6 Set Object Removal
Detecon
It detects whether the objects are removed from the predened detecon region, such as the
exhibits on display. If it occurs, the device can take linkage acons and the sta can take measures
to reduce property loss.
Before You Start
For certain device models, you need to enable the smart event funcon on VCA Resource page
rst.
Steps
1.
Go to VCA → Smart Event → Object Removal Detecon . For certain device models, you should
go to Conguraon → Event → Smart Event → Object Removal Detecon .
2.
Check Enable.
3.
Select a region. For the
detecon region sengs, refer to Draw Area .
4.
Set the minimum size and the maximum size for the target to improve
detecon accuracy. Only
targets whose size are between the maximum size and the minimum size trigger the detecon.
For the detail sengs, refer to Set Size Filter .
5.
Set the rule.
Network Camera User Manual
96