HIKVISION DS-2XS6A87G1-LS/4G - Uploading Pictures Settings

2.
Check Enable.
3.
Select the total number of lanes.
4.
Click and drag the lane line to set its posion, or click and drag the line end to adjust the length
and angle of the line.
5.
Adjust the zoom rao of the camera so that the size of the vehicle in the image is close to that of
the red frame. Only the
posion of red frame is adjustable.
Note
Only 1 license plate can be captured at one me for each lane.
6.
Select Region and Country/Region.
7.
Check Remove Duplicated License Plates and set Time Interval. The default me interval is 4
minutes.
8.
Set arming schedule and linkage method. For the arming schedule
sengs, refer to Set Arming
Schedule . For the linkage method sengs, refer to Linkage Method Sengs .
9.
Click Save.
10.4.3 Uploading Pictures
Sengs
You can set the image parameters of the captured images in vehicle detecon and mixed-trac
detecon.
Go to VCA → VCA Resource , and select Road Trac.
Go to VCA → Road Trac → Picture .
Picture Quality
The larger the value is, the clearer the picture is, but larger storage space is also required.
Picture Size
The larger the value is, the larger the storage space is needed. And the level of network
transmission requirement is also higher.
Picture
Resoluon
The captured background picture resoluon.
Picture Capture Interval
The camera supports connuously trigger the alarm and upload captured picture each interval.
Check Picture Capture Interval and set the interval.
License Plate Enhancement
The larger the value is, the clearer the license plate is, but larger storage space is also required.
Check License Plate Enhancement and set the level. The default level is 50.
Note
Only certain device models support this funcon.
Network Camera User Manual
99