HIKVISION DS-2XS6A87G1-LS/4G - Lens Initialization; Quick Set Live View; Lens Parameters Adjustment

Note
●
If the device cannot focus with auxiliary focus, you can use Lens Inializaon , then use auxiliary
focus again to make the image clear.
●
If auxiliary focus cannot help the device focus clearly, you can use manual focus.
3.1.10 Lens Inializaon
Lens inializaon is used on the device equipped with motorized lens. The funcon can reset lens
when long me zoom or focus results in blurred image. This funcon varies according to dierent
models.
Manual Lens Inializaon
Click to operate lens inializaon.
Auto Lens Inializaon
Go to Conguraon → System → Maintenance → Lens Correcon to enable this funcon. You
can set the arming schedule, and the device will correct lens automacally during the
congured me periods.
3.1.11 Quick Set Live View
It oers a quick setup of PTZ, display sengs, OSD, video/audio and VCA resource sengs on live
view page.
Steps
1.
Click to show quick setup page.
2.
Set PTZ, display
sengs, OSD, video/audio and VCA resource parameters.
-
For PTZ
sengs, see Lens Parameters Adjustment .
-
For display
sengs, see Display Sengs .
-
For OSD sengs, see OSD .
-
For audio and video
sengs, see Video and Audio .
-
For VCA sengs, see Allocate VCA Resource .
Note
The funcon is only supported by certain models.
3.1.12 Lens Parameters Adjustment
It is used to adjust the lens focus, zoom and iris.
Network Camera User Manual
8