HIKVISION DS-2XS6A87G1-LS/4G - Access to Device Via AP

Cauon
We highly recommend you create a strong password of your own choosing (using a minimum
of 8 characters, including upper case leers, lower case leers, numbers, and special
characters) in order to increase the security of your product. And we recommend you reset
your password regularly, especially in the high security system,
reseng the password
monthly or weekly can
beer protect your product.
4.
Click Save.
Note
The funcon may vary according to dierent device models.
What to do next
You can connect your mobile phone or PC to the AP.
7.9.2 Access to Device via AP
You can access to the device via the device AP when the device cannot connect to the network.
Steps
1.
Go to Conguraon → Network → Advanced Sengs → WLAN AP to enable WLAN AP
funcon.
For certain device models, the WLAN AP funcon is automacally turned on for 5 minutes aer
the device is cold booted (by turning the switch on the device to ON), aer which the WLAN AP
funcon is turned o if the device's 4G communicaon is normal, and remains on if the device's
4G communicaon is abnormal.
2.
Search the device WLAN AP in the WLAN list of your phone or PC.
3.
Enter the password and connect your mobile phone or PC to the AP.
Note
The AP name is SSID ("Hik-Serial Number" by default). The password is serial number by default.
The serial number can be obtained from Conguraon → System → System Sengs → Basic
Informaon .
4.
Enter the IP address in the browser.
Note
The default IP of the device AP is 192.168.8.1.
Result
The connected devices will be displayed in the Connected Device interface from Conguraon →
Network → Advanced Sengs → WLAN AP .
Network Camera User Manual
60